1、 為使涂裝達到完美效果，我公司建議：對于尚未找平的地面我公司參與工地的水泥找平層的找平處理。土建方找平時，在水泥初凝時用我公司專業地面機械對地面進行磨平處理。在此基礎上所做的環氧涂裝層的表面效果會更平整、光亮，使用壽命也會提高。

1, in order to make the painting to achieve the perfect effect, I suggest: leveling cement screed for not leveling the ground my participation in the site. Construction for peacetime, to ground polished processing in jelling with my company specializes in mechanical ground. The effect of the surface of the epoxy coating on this basis will be more smooth, bright, life will improve.

2、 待水泥層干燥后（大約 28 天），用打磨機對地面進行整體打磨處理，使其表面平整，水泥毛細孔全部張開。

2, when the cement layer is dried (about 28 days), on the ground of whole polished by grinding machine, the surface smooth, cement pores fully open.

3、 對于水泥地面有油污（食用油、機油），先用專用洗劑沖洗地表面，反復擦洗，直到無油污為止。

Oil 3, for the cement ground (edible oil, oil), first flush using special lotion to the surface, repeated scrubbing, until no oil.

4、 對于地坪堿性太大（ PH>8 ）的，先用專用材料中和，然后用清水沖洗；

4, the floor too alkaline (PH>8), first with special material and, then rinse with water;

5、 對于潮濕的地面，通過吸水。擦干，太陽燈照，熱風機吹烘、燒，使其干燥達到施工要求。

5, for the wet ground, through the water. Dry, sun light, hot air blowing drying, burning, dry meet construction requirements.

6、 對于有舊油漆的地面（如金剛砂地面、舊油漆地面），先用專用機械鏟除舊油漆，然后對不良水泥、金剛砂地面進行處理同時對地面打毛。地面經過這樣處理后，不牢固的舊水泥及金剛砂表面被清除掉，并且形成粗毛面，從而提高新涂層的附著力，提高涂裝地坪的使用壽命。

6, for the old paint surface (such as carborundum floor, old paint surface), first with the machinery for the eradication of the old paint, then the bad cement, emery ground processing at the same time on the ground dozen hair. The ground after this treatment, not solid old cement and sand surface is removed, and the formation of rough surface, so as to improve the coating adhesion, improve the service life of the coating.